QJ-A3S Fully Automatic Blow Molding Machine 3 Cavity

●Use 1 servo design, speed fast, more stable.

●Electricity safe, 1 preform transferwith servo, can safe a lot of air energy consumption and positioning more accurate and machine running more stable. 

●The installation mode of the mold is “drawer push type” positioning installation up and down. The workers only need to operate and replace the mold on the ground, which is safer, more convenient and more efficient.

●After blowing the bottle will automatically ejected from mould, no need worker to take the bottle can avoid worker injury during machine operation. 

●Preform reheated adopt hanging infrared lamps reheat design, center distance of the preform when reheated small so the speed for reheat will be faster, can safe electricity about 30% compare to market similar machine. Infrared lamps wave can pass through the inside the preform, so the inner and outer of the preform can get the same temperature can ensure the bottle get a perfect transparency and good appearance.